CiscopyATS

🔧 Cisco pyATS + Genie Test Suite

This repository contains two test cases built using Cisco pyATS + Genie, targeting IOS and IOS-XE routers. These tests validate ping connectivity and static route consistency across two routers.

---

📋 Test Environment

Router Name	Platform	IP Address	OS	Protocol
iosv-0	IOS	192.168.30.182	ios	SSH
csr1000v-0	IOS-XE	192.168.30.183	iosxe	SSH

Both routers must be reachable over SSH and allow CLI access for ping and show ip route.

✅ Overview

Devices:

iosv-0 – 192.168.30.182 (IOS)

csr1000v-0 – 192.168.30.183 (IOS-XE)

---

✅ Test Cases

Test Case 1: Ping Success Rate

• Command: ping 100.1.1.1
• Validation: Verifies the ping result contains the string "Success rate is 100 percent"
• Pass Criteria: Both routers must return exactly 100% success rate
• Fail Criteria: Any router with less than 100% will fail the test

Testcases:

Ping 100.1.1.1 and verify "Success rate is 100 percent"

Compare static routes ("S") from show ip route

---

Test Case 2: Static Route Comparison

• Command: show ip route
• Validation:
  • Extracts all routes starting with "S" (Static routes)
  • Compares the route prefixes from both routers
• Pass Criteria: Static routes must match exactly
• Fail Criteria: Any mismatch in static route prefixes causes the test to fail

---

🗂 Project Structure

🔒 Requirements

Python 3.8+

pyATS and Genie installed: pip install pyats[full]

SSH access to routers with valid credentials

Static routes configured on both routers (if test 2 is expected to pass)

📦 Future Enhancements

Add retry logic for ping

Support for dynamic route types (O, B, E, etc.)

Use Genie parsers instead of CLI regex for better accuracy