Display

Measurements

The display can show 3 different sensorChannels. These 3 'lines' are numbered 0 .. 2 from top to bottom. You can define which sensorDevice/sensorChannel is shown on which line in two ways:

• via the command-line interface
• via LoRaWAN Downlink

Note : when configuring the display to show a sensorChannel, make sure this sensorChannel is also configured as enabled (outputting measurements). Showing a sensorChannel which is disabled will show value 0.

Status bar

This display always shows a status bar at the bottom with the following info:

• name of the device - see set name
• USB connection present or absent
• LoRaWAN network signal strenght
• battery charging level