Skip to content

About

No description, website, or topics provided.

Resources

Stars

0 stars

Watchers

0 watching

Forks

Latest commit

 

History

12 Commits

Folders and files

NameName
Last commit message
Last commit date
 
 
 
 
 
 
 
 

Repository files navigation

Pick and Place Robotic Arm

🤖 Project Summary

This project is a 4-axis robotic arm designed for automated "Pick and Place" tasks. It uses an Arduino microcontroller and software to control four servo motors: one for the base, two for the arm segments, and one for the gripper. The system is powered by an external 5V power supply to ensure stable movement.

⚙️ Hardware & Software Requirements

Hardware

  • Microcontroller: 1x Arduino Uno
  • Actuators: 4x Servo Motors
    • 1x SG90 (or MG996R) for Base
    • 2x MG996R (or similar high-torque) for Arm/Shoulder
    • 1x SG90 for Gripper
  • Power Supply: 1x External 5V 2A (or higher) DC Power Supply
  • Misc:
    • Breadboard
    • Jumper Wires
    • Robotic Arm Kit (as pictured)

Software

  • IDE: Arduino IDE or VS Code with PlatformIO
  • Libraries:
    • Servo.h (comes pre-installed with the Arduino IDE)
  • Arm contol software

🔧 Setup Instructions

  1. Assemble Hardware: Build the robotic arm kit according to its manual.
  2. Connect Electronics: Wire the components as shown in the Connection Diagram section below. Warning: Do NOT power the servos directly from the Arduino's 5V pin. This will damage the Arduino. You MUST use an external 5V power supply.
  3. Upload Code:
    • Clone this repository.
    • Open the main_code file in your Arduino IDE.
    • Select "Arduino Uno" as your board and the correct COM port.
    • Upload the sketch.
  4. Test: The arm will move to its "home" position and then begin its automated pick-and-place sequence.

📸 Project Image

(This is the 61KNgjbdupL._SY606_.jpg you provided. It should be saved in the docs/diagrams/ folder.)

Photo of the 4-axis robotic arm

🧩 Block Diagram Image

(This is the diagram from your previous upload.)

Block Diagram

##Project Connection connection

Software (https://drive.google.com/drive/folders/155aWvKH5jcQ96tFvs-LeDclDERoTMNEt)

📄 Paper or Report Link

For a detailed explanation of the project, including design choices, kinematics, and results, please see the full report.

Read the Full Project Report (PDF)

🙏 Acknowledgements

This project's code and logic were inspired by and referenced from the following tutorial:

A big thank you to FABRI creator for sharing their excellent work with the community.

About

No description, website, or topics provided.

Resources

Stars

0 stars

Watchers

0 watching

Forks

Releases

Packages

Contributors