I installed Loop after not having used it for a few years. My previous appsettings were pulled in from an old cloud save which had a correction range less than what is typically recommended (85 -85). When I click on the setting to edit it I am kicked out to the home screen of the phone. Clicking "+" to add a range setting causes the same outcome.
To Reproduce
Steps to reproduce the behavior:
- Go toTherapy Settings -> Correction Range
- Click on "+" or the range listed.
- At this point I am being kicked out to the home screen. Loop is still running.
Expected behavior
I should be able to edit the correction range if it is shown to be outside of the typical #range
Phone
- Hardware: iPhone 14
- OS Version: 26.5
Loop Version
Loop Report 2026-06-16 18_06_54-05_00.md
- Version Number: 3.14.2
- Repo: LoopKit
CGM
- Device: Dexcom G7
- Manager app: Dexcom App
Pump
- Manufacturer: OmniPod
- Model: Dash
- Firmware version: 11.7.0
I installed Loop after not having used it for a few years. My previous appsettings were pulled in from an old cloud save which had a correction range less than what is typically recommended (85 -85). When I click on the setting to edit it I am kicked out to the home screen of the phone. Clicking "+" to add a range setting causes the same outcome.
To Reproduce
Steps to reproduce the behavior:
Expected behavior
I should be able to edit the correction range if it is shown to be outside of the typical #range
Phone
Loop Version
Loop Report 2026-06-16 18_06_54-05_00.md
CGM
Pump